JZZ30
- manjidrift
- Power Junkie

- Posts: 248
- Joined: Tue Dec 26, 2006 2:10 pm
Re: JZZ30
4.11 Torsen? JZX cars use the same one for the manual right?
-
motion sickness
- Power Junkie

- Posts: 767
- Joined: Tue Aug 14, 2007 11:19 pm
Re: JZZ30
No such thing as 4.11. Aristo/supra auto Torsen rear ends have 3.76 gears. Soarers and TT-R have 4.10 gears.
-
motion sickness
- Power Junkie

- Posts: 767
- Joined: Tue Aug 14, 2007 11:19 pm
Re: JZZ30
Checkout the XXR 531. Those are the replicas to the CCWs.
-
Sikes
- Boost Freak

- Posts: 161
- Joined: Thu Feb 19, 2009 11:23 am
Re: JZZ30
Did some gtech runs, best run was 13.88@104 mph say the car is around 330whp.
Well the gtech run is informative and may need to do the following:
1. remove speed cut. I am really wondering if I am hitting speed cut before the quarter mile ends, 6mph is the difference between max speed and speed cut, with 17inch rim throwing off the speed counter and well how accurate would the speedometer be compared to current tech.
2. Car can't go past 15-16 psi, it spikes and then drops below 15, wanted to run 18psi, was thinking weak ignition but now just thinking we pulled to much timing and the flow from the cams and retard timing is choking the turbos
3. Driver needs modding (launching at too low rpms and then granny shifting some gears, lol)
Short vid not sure will post.
Well the gtech run is informative and may need to do the following:
1. remove speed cut. I am really wondering if I am hitting speed cut before the quarter mile ends, 6mph is the difference between max speed and speed cut, with 17inch rim throwing off the speed counter and well how accurate would the speedometer be compared to current tech.
2. Car can't go past 15-16 psi, it spikes and then drops below 15, wanted to run 18psi, was thinking weak ignition but now just thinking we pulled to much timing and the flow from the cams and retard timing is choking the turbos
3. Driver needs modding (launching at too low rpms and then granny shifting some gears, lol)
Short vid not sure will post.
No 18motion sickness wrote:Checkout the XXR 531. Those are the replicas to the CCWs.
-
Sikes
- Boost Freak

- Posts: 161
- Joined: Thu Feb 19, 2009 11:23 am
-
Sikes
- Boost Freak

- Posts: 161
- Joined: Thu Feb 19, 2009 11:23 am
Re: JZZ30
Got a hx35 with a Bep .70 back housing on the way, that is how it behaves on a 1jz with similar mods to mine.
http://vimeo.com/24825442
http://fctuning.com/fctwp/?p=1852
http://vimeo.com/24825442
http://fctuning.com/fctwp/?p=1852
-
motion sickness
- Power Junkie

- Posts: 767
- Joined: Tue Aug 14, 2007 11:19 pm
Re: JZZ30
Just remember that car is dyno tuned. You will get some gains, but not what you saw on the vid.
-
Sikes
- Boost Freak

- Posts: 161
- Joined: Thu Feb 19, 2009 11:23 am
Re: JZZ30
If all goes how I want, should do more. That car had 550cc injector emanage blue and map sensor, to that I already have to add meth injection, 650cc injector, hks cam and hopefully at some point emanage ultimate. With a good tune I would expect more, but lets see. Anything close to that would be ok, where things would really need to step up is if we on a track somewhere.
-
Sikes
- Boost Freak

- Posts: 161
- Joined: Thu Feb 19, 2009 11:23 am
Re: JZZ30
Very interesting.
http://www.microsofttranslator.com/bv.a ... /myengine/
http://www.microsofttranslator.com/bv.a ... /myengine/
