Re: Project: Response
Posted: Tue Apr 17, 2007 1:37 am
the 3sge is 86mmx86mm bore x stroke this makes it a square motor like say for example the 2jzgte... going with 5s crank makes it off square and strokes it.
Anyways today we put a lil more time into Tearing down the engine. Got the crank and end caps off. Upon inspection of the bearings, the Sand really got to #1 and #2 rod bearing and main bearing cause they were totally thrashed.
We couldn't find the right side Allenkey to get the head off so tommorow we will be going back over to get some more work done