Page 6 of 13
Re: Project Response and Well Handling VR4
Posted: Wed Jul 07, 2010 7:37 pm
by scientist
Work has begun on the manual conversion
Re: Project Response and Well Handling VR4
Posted: Tue Jul 20, 2010 12:12 am
by ceelos
engine and tranny out, turbo one removed from engine... transfercase almost out.. transmission held by one bolt still...
Work continues....
Re: Project Response and Well Handling VR4
Posted: Tue Jul 20, 2010 11:52 am
by TheGoodGuy
cee wrote:engine and tranny out, turbo one removed from engine... transfercase almost out.. transmission held by one bolt still...
Work continues....
Hmmm.. why allu removing the tubo's again?.. going and do an upgrade porklos?
Re: Project Response and Well Handling VR4
Posted: Tue Jul 20, 2010 12:57 pm
by scientist
they dead....gone...no coming back
Re: Project Response and Well Handling VR4
Posted: Sun Jul 25, 2010 5:52 pm
by boost_leeroy
What plans do you guys have for the turbos and fueling?
Also how do you guys plan to tune the car?
Re: Project Response and Well Handling VR4
Posted: Sun Jul 25, 2010 10:41 pm
by scientist
this should answer your questions
Turbo kit is not exact plans...but its along those lines. Injectors and Fueling are along those lines except a few minor differences to address some issues that may arise. Tuning will be done through the Stock ECU
Re: Project Response and Well Handling VR4
Posted: Tue Jul 27, 2010 5:26 pm
by chemist
but who tell allyou the owner can handle stick???
Re: Project Response and Well Handling VR4
Posted: Tue Jul 27, 2010 6:53 pm
by TheGoodGuy
He learn on a Datsun that go down a cliff... and when he was a real driver.. on a toyota ..
Re: Project Response and Well Handling VR4
Posted: Tue Jul 27, 2010 11:18 pm
by ceelos
the guy can handle stick so have no fear.. keep that in mind..
Re: Project Response and Well Handling VR4
Posted: Sun Aug 01, 2010 6:17 pm
by scientist
Well progress has been made:
Trans is off now, new main seal arrives on thursday so the Manual trans will mount month end.
Shifter mounted and shifter cables ran.
Brake pedals swapped.
On tuesday we will drill out the holes for the clutch slave.
Have a bit of wiring to clear away