Onlydominican.com

scientist wrote: Need $$$$$$$$$$$$$$$$

All that money you made for Carnival!! You even have people lol at me re my pic on Carnival.DA

lol i wish i made a lot of money

well since i haven't had time lately to give the car any attention and things kinda slow with sourcing some of the parts

i'll just let u guys kinda see some of my inspiration for this project

Well as i start removing parts for full servicing i start uncovering quite a bit of puzzling occurances. to make a long story short, i now gotta get a transfer case and drive shaft to add to the rear axles.


But anyways moving onto the project
Over the weekend i began prepping my N/a head for transplant onto the block. Since this was a used head it had quite a bit of carbon build up but during the week when i get back my dremmel tool and a few grits of sand paper i will polish the ports and the valves.

After a few stints of degreaser the head started looking like something again


Valves getting ready to be ground


Berky Begins grinding valves


And me taking a turn at it


Me spraying the degreaser on


Almost cleaned head *Project Reponse Head in the background


VR4 engine bay

What wrong with the transfer case?

Missing

DGLOBE69 wrote: QUESTION, "WHAT ARE YOU PLANNING ON DOING IN THIS PROJECT?

sorry i missed your question


Stage 1 on this project is Restoration...just Getting the car to a point where i am happy and it can be daily driven.

From there i will decide what direction i will take on mods

Project Plans updated to reflect current goals.

looking good so far.

Have:
Drive Shaft
3 bolt Rear axles - Soon for Sale
Transfercase


Ordered:
4 Bolt LSD Rear end
4 bolt axles and cups
5 lug spindles and hubs
solid shifter bushings
2G GSX MAF+Pigtail Harness
5 Lug conversion (Gonna have to put the rims further up the list)

On Wait List
Evo 3 Turbo
Evo 3 Exhaust Manifold
Evo 3 O2 housing
Evo 3 Intake Manifold
Denso 660cc injectors (Stock 530s may be sold soon)