Page 4 of 12
Re: KA24DE-T
Posted: Tue Apr 03, 2007 6:02 pm
by SF5
Sweet Response (written on windshield lol) and my S13
Manual tranny swap freshly done
Clean but I broke the CrankCase vent hose
Re: KA24DE-T
Posted: Tue Apr 03, 2007 6:12 pm
by SF5
Pulled Old Fuel Pump for walbro drop in, hate that bloody salt they put on the road causes rust everywhere
Old pump
Old pump bigger than walbro wierd
Fuel Pump mounted
The pump is now installed, the car starts quicker now, pump is not quiet at all!
Re: KA24DE-T
Posted: Tue Apr 03, 2007 8:37 pm
by Silent_NightR34
your trying to run 21psi with the stock block???
Re: KA24DE-T
Posted: Tue Apr 03, 2007 9:27 pm
by SF5
yep..... y?
Re: KA24DE-T
Posted: Tue Apr 03, 2007 10:01 pm
by ceelos
i hear them pumps in action already. makes u think a tire loosing air...
Re: KA24DE-T
Posted: Tue Apr 03, 2007 11:42 pm
by SF5
It is noisy but it helps my injectors tick less which indicates a rise in pressure. Waiting for a few more parts .. I hate waiting. meanwhile I am gonna take care of the battery relocation and relocate the fuse box. During the tranny swap I saw that the front tension rod bushings are shot! That's gonna be replace with Megan Racing Adjustable T.R, then front lip, rims and suspension.
Re: KA24DE-T
Posted: Sun Apr 08, 2007 7:33 pm
by SF5
Finally I have acquired 99% of the must have pieces for a strong reliable setup (weak link being the 9.0:1 comp ratio stock pistons & head gasket)
T3/T70 .84 a/r (v-band)
Tial 50mm BOV
Revised SSAC Manifold
32x12x4 Intercooler
50mm Wastegate
Custom wastegate dumptube
MSII V3.0 full standalone
5F Tranny
clutch pedal
Driveshaft
shift boot
B&M short Shifter
CBR 600F4i coils w/harness
DSM Ignition System (DIS lol)
Walbro Fuel Pump
3" V-Band Flange
3" Catback Exhaust
3" Custom Downpipe
4" Custom Turbo Induction Kit
Custom Oil feed/Return Kit
Custom 2.75" Intercooler Piping kit
T-Bolt Clamps
That was the easy part,
Engine Management duties will be handled by MSEFI full standalone set up with C.O.P, and some inguinuity to come up with a one of a kind setup!
Stay tuned for installation pics for this and completion of the other 240sx
Re: KA24DE-T
Posted: Sun Apr 08, 2007 10:40 pm
by skidmarx
am reading
Re: KA24DE-T
Posted: Sun Apr 08, 2007 10:52 pm
by scientist
subscribed
Re: KA24DE-T
Posted: Mon Apr 09, 2007 12:24 am
by SF5
Last minute change, just realised I could get Topfeeds and a rail for the cost of side feeds...so my order was changed last minute should be here friday latest. So that's 1000cc injectors and Project silvia fuel Rail... Now I am at it I wanna just get an aftermarket fuel Filter (10micron) AN fittings and fuel lines from summitracing.